Extron electronic USP 405 Appendix, cont’d, Installed SDI input card, Installed SDI output card

Appendix, cont’d

J23

1 2 3

3

J23 1

7.For the SDI input card installation, insert the card’s installation screw through the SDI card’s mounting hole and gently tighten it into the standoff. See the picture below.

Installed SDI input card

For the SDI output card installation, the card should be positioned in place as shown below.

Installed SDI output card

8. Install the SDI connector’s hex nut and keep the SDI card from twisting as the nut is tightened.

9.For the SDI input card installation, move the jumper on J23 (see the illustration on page A-7) from pins 1 and 2 (no SDI input card present) to pins 2 and 3 (SDI input card present).

10.Replace the top cover on the USP, and fasten it with the screws that were removed in step 3.

11.Rack or furniture mount the USP 405, and reconnect the AC power cord.

A-10 USP 405 • Appendix