Extron electronic Installing labels in the USP 405’s buttons, Serial Communication, cont’d

Serial Communication, cont’d

2.Under System selection, choose the System 7SC. This selection creates the correctly sized labels for the USP’s buttons. The button label editing area changes to reflect the number and arrangement of buttons on the device.

3.Using normal Windows controls, you can create and print labels that can be cut out and placed in the label windows on the front panel of the USP.

For information about using the program, you can access a help file by clicking on the Help menu on the main screen and choosing Show Help.

You can also see an example of a completed Extron Button-Label Generator window by clicking on the Help menu on the main screen, choosing Show Help, and clicking the Load Demo button.

The following picture shows the Button-Label Generator screen.

Button label screen

Installing labels in the USP 405’s buttons

Use the following procedure to install new labels in the USP 405’s front panel buttons.

1.Make new labels by using the Button-Label Generator software (see the previous page). Print them and cut them out.

2.Remove a button from the USP by grasping the button firmly and pulling it away from the front panel.

3.Use a tweeker to gently lever the button cap off of the white backing plate.

4.Insert a button label into the cap and gently but firmly press the cap onto the white backing plate.

5.Press the button into place in the front panel.

Use notch to remove button

Separate two piece button here

3-10 USP 405 • Serial Communication