Extron electronic USP 405 IR 801 Infrared Remote Control, Selecting an input, Freezing an input

IR 801 Infrared Remote Control

The optional IR 801, shown at right, replicates all of the front panel controls except the Menu and Next buttons. If Executive mode is enabled, selections and adjustments can still be made using the IR 801, but you must use the USP 405’s front panel or the Windows-based control program (via an RS-232 device) to configure and program the USP. See chapter 3, “Serial Communication”, for details.

While Executive mode is active, adjustments can still be made using the IR 801.

The topmost part of the IR 801 features three aspect ratio preset buttons, a horizontal filters button, a freeze button, and a vertical filters button.

The horizontal and vertical filtering apply only to the following input formats:

Input 1: RGB

Input 2: RGB, YUVp, HDTV

The middle portion of the IR 801 features five input selection buttons, the size buttons for sizing an image, and the shift buttons for centering an image.

The bottom portion of the IR 801 contains the adjustment controls for color, tint, brightness, contrast, detail, and zoom adjustments.

Selecting an input

To use the IR 801 to select an input, press the button corresponding to the input number.

Freezing an input

To freeze the input being displayed, press the Freeze On/Off button. To unfreeze the input, press the Freeze button again.

Aspect ratio presets

Up to three saved memory presets may be recalled by pressing one of the three Aspect ratio preset buttons. Sizing and centering information are saved with the presets.

USP 405 • Installation and Operation 2-21