Extron electronic manual ASCII Command Response, values, USP 405 Serial Communication

The syntax for setting a special function is X? * X! # where X? is the function number and X! is the

value. To view a function’s setting, use X? # where X? is the function number. In the following table the values of the X? variable are different for each command/function. These values are given in the far right column.

Command/response table for special function SIS commands

Command	ASCII Command Response			values
			X!
	(host to USP)	(USP to host)	and additional descriptions

Delay times

RGB delay (Triple-Action Switching) 3 *

X!

#Dly

X!

0 = 0.0 seconds (default), 1 =

0.1seconds, 2 = 0.2 seconds,

... in 0.01 second steps up to 50 = 5.0 seconds.

Example: 3*35# Dly35 RGB delay set to 3.5 seconds.

Encoder filter.

Switching effect	10 *	X!
Example:	10*3#

#Enc X! Enc03

Encoder values 0 through 12. Encoder set to 3.

Scaler settings

Output signal	6 *	X!
Example:	6*1#
Output polarity	7 *
		X!
Example:	7*1#

#Tpo X!

Tpo1

#Pol X!

Pol1

0= RGB (default).

1= R-Y, Y, B-Y.

RGB output signal

0= H-/V- (default).

1= H-/V+.

2= H+/V-.

3= H+/V+.

Example: H-/V+ output polarity

Blue screen

Blue screen (blue & sync output only) 8* X!

Example:8*1#

#	Blu	X!	0 = off (default) (RGB & sync
			output).
			1 = on (blue video & sync
			output only).
	Blu1		Blue & sync output for setup.

Edge smoothing

Edge enhancement 16* X!

Example:16*1#

#Fil X!

Fil1

0 = off.

1 = on (default).

Enable edge smoothing.

Enhanced mode

Enhanced mode 12 * X!

Example:12*1#

#Enh X!

Enh1

0= off (default).

1= on.

Example: Enable enhanced mode.

PAL Film mode (2:2 pulldown detection)

PAL film mode detection	18 *	X!	#	Flm	X!
Example:	18*1#			Flm1

0= off (default).

1= on.

Example: Enable PAL film mode detection.

USP 405 • Serial Communication 3-7