Advanced Configuration
The following flowchart provides an overview of the Advanced Configuration submenus and the options for each setting.
Output
Configuration
MENU
Advanced
Configuration
Either Adjust knob is used to adjust the submenus*
NEXT
Edge Smoothing
OFF <ON>
NEXT
Encoder Filter
06
NEXT
Blue Mode
<OFF> ON
NEXT
Test Pattern
Off
NEXT
Smooth edges
•On (default)
•Off
Encoder filter setting
•0 thru 12 (default is 6) to adjust sharpness
Display blue and sync only
•On
•Off (default)
Set test pattern type
• Off (default) | • Alt pixel |
• Color Bars | • Film aspect 1.78 |
• Crosshatch | • Film aspect 1.85 |
• 4 x 4 crosshatch | • Film aspect 2.35 |
• Grayscale | • Ramp |
• Crop |
|
Top Blanking Bot
021 030
NEXT
RGB Delay
0.2Seconds
NEXT
Enhanced Mode
<OFF> ON
NEXT
Press and Hold FREEZE to Reset
NEXT
Input 2 PAL Film
<OFF> ON
NEXT
Top and Bottom Blanking*
•Top blanking ranges from 000 (default) to 237
•Bottom blanking ranges 000 (default) to 237
RGB delay time
(in seconds)
•0.0 to 5.0 seconds
in 0.1 sec. increments (0.7 second default)
Enhanced mode (gain control)*
•On (default)
•Off
To reset the scaler, press and hold the Freeze button until reset message displays
NOTE Adjust knobs do not affect
this submenu.
PAL Film Mode
•On
•Off (default)
*If the Test Pattern is set "On",
"Not Available" is displayed.
Edge Smoothing submenu
This submenu features edge smoothing. Edge smoothing smooths the edges of a picture by minimizing the differences between pixels.
Using either the horizontal Adjust () or vertical Adjust () knob, select either “On” or “Off”. The default is “On”.
Encoder Filter submenu
This submenu adjusts the sharpness of the displayed image. The sharpness can be set from 0 to 12 (maximum). The default is 6.
Using either the horizontal Adjust () or vertical Adjust () knob, adjust the filter for the desired sharpness level.
Blue Mode submenu
To aid in setup of the USP 405’s color and tint, the Blue Mode can be set from this submenu to “On” so that only sync and blue video signals will be passed to the display. Use either the horizontal Adjust () or vertical Adjust () knob to specify this mode. The default is “Off”.
Test Pattern submenu
In this submenu, several test patterns are provided to help adjust the display device for color, convergence, focus, resolution, contrast, grey scale, and aspect ratio. Use either the horizontal Adjust () or vertical Adjust () knob to select a test pattern. The options are: Off, Color Bars, Crosshatch, 4 x 4 Crosshatch, Grayscale, Crop, Alternating Pixel, Film Aspect Ratios 1.78/1.85/2.35, and Ramp. The default is “Off”.
The Alternating Pixel and Ramp test patterns are not available for NTSC or PAL output rates. If one of these patterns is on when the output rate is switched to NTSC or PAL, the test pattern changes to color bars.
USP 405 • Installation and Operation