Extron electronic USP 405 Menus, Configuration, and Adjustments, Menu overview, Default Cycle

Installation and Operation, cont’d

Menus, Configuration, and Adjustments

USP 405 configuration and adjustments can be performed by using the Windows-based control program (see chapter 3 for details) or by using the front panel controls and the menus that are displayed on the USP’s LCD screen. These menus are used primarily when the USP is first set up.

Moving through menus by using front panel controls

Power

on

Menu button — Press the Menu button to activate menus and to scroll to the five main menus.

Next button — Press the Next button to move between the submenus of a selected main menu. Pressing the Next button during input configuration causes the current input’s number and format type to be displayed on the LCD.

Adjust (, ) knobs — In configuration mode rotate the horizontal Adjust () knob and vertical Adjust () knob to scroll through submenu options and to make adjustment selections. Refer to the flowcharts in this chapter and to specific sections for explanations on knob adjustments.

Image adjustment buttons: Center, Size, Brt/Cont (brightness/contrast), Col/Tnt (color/tint), Zoom, and Detail — When one of these buttons is pressed, the corresponding image adjustment menu appears on the LCD screen.

Adjustments can then be made by rotating the horizontal Adjust () knob or the vertical Adjust () knob. Settings and adjustments are stored in nonvolatile memory.

Menu overview

The default screens appear on the LCD when no adjustments are actively being made. When the USP 405 is powered up, the LCD displays a screen showing the USP model (USP 405/USP 405 I/ USP 405 O/ USP 405 IO) for approximately

2 seconds, then the model number and firmware version for approximately

2 seconds, and then the LCD cycles among screens showing the active input’s number and video format, the input’s horizontal and vertical frequencies, and the output resolution and refresh rate, as shown below.

Extron							Default Cycle
USP 405	SDI I
Extron			60-369-0x		Input #1		Horz. 00.00 KHz		Output Rate
USP 405	SDI O	2 sec.	Version x.xx	2 sec.	RGBHV	2 sec.	Vert. 00.00 Hz	2 sec.	1024 x 768 @ 60
									2 sec.
Extron
USP 405	SDI IO

Default menus

From any menu or submenu, after ten seconds of inactivity the USP 405 saves all adjustment settings and times out to the default screens.

The main menus are shown in the following flowchart. Use the Menu button to scroll between them and the Next button to activate one for viewing or configuration.

2-12 USP 405 • Installation and Operation