Craftsman 139.53993D owner manual One-Piecedoors

ONE-PIECEDOORS

Please read and comply with the warnings and reinforcement instructions on the previous page. They apply to one-piece doors also.

•Center the door bracket on the top of the door, in line with the header bracket as shown. Mark either the left

and right, or the top and bottom holes.

•Drill 5/16" pilot holes and fasten the bracket with hardware supplied.

If the door has no exposed framing, drill 3/16" pilot holes and fasten the bracket with 5/16"x1-1/2" lag screws (not provided) to the top of the door.

HARDWARE SHOWN ACTUAL SIZE

©

Nut 5/16"-18 LockWasher 5/16"

NOTE: The door bracket may be installed on the top edge of the door if required for your installation. (Refer to the dotted line optional placement drawing.) Drill 3/16" pilot holes and substitute 5/16"x1-1/2" lag screws (not provided) to fasten the bracket to the door.

Header Wall

2x4

Header

Bracket

Door

Bracket

Optional

Placement

of Door

Carriage Bolt 5/16"-18x2-1/2"

HorizoetaU and vertical

reinforcement is needed for doors

(fiberglass, aluminum, steel door with gUass panel, etc.). (Not Provided)

Bracket

Vertical

Centerline

of Garage

Door

For a door with no exposed framing, or for the optional installation, use

5/16"x1-1/2" lag screws (Not Provided) to fasten door bracket.

®

Lock

,Washer

5/16"

Top of Door

Top Edge

of Door

Optional

Placement

Carriage Bolt

5/16"-18x2-1/2"

24