Craftsman 139.53993D owner manual Using the Wall.Mounted Door Control, To Open the Door Manually

Using the Wall.Mounted		Door Control
THE PREMIUM	CONTROL
CONSOLE			Lighted
			Push Button
Press the lighted	push button to open I _		-_-_._
or close the door. Press again to
reverse the door during the closing			Light
cycle or to stop the door while it's			utton
opening.			Lock
			Button

Light feature

Press the Light button to turn the opener light on or off. It will not control the opener lights when the door is in motion. If you turn it on and then activate the opener, the light will remain on for 4-1/2 minutes. Press again to turn it off sooner. The 4-1/2 minute interval can be changed to 1-1/2, 2-1/2, or 3-1/2 minutes as follows: Press and hold the Lock button until the light blinks (about 10 seconds).

To Open the Door Manually

To prevent possible SERIOUSINJURY or DEATHfrom a falling garagedoor:

•If possible, use emergency release handleto disengage trolley ONLYwhen garage door is CLOSED.Weakor broken springs or unbalanceddoor could result in an open door falling rapidly and/or unexpectedly.

•NEVERuse emergency releasehandle unless garage doorway is clear of persons and obstructions.

•NEVERuse handle to pull door open or closed. If rope knot becomes untied, you could fall.

DISCONNECT THE TROLLEY:

A single blink indicates that the timer is reset to 1-1/2 minutes. Repeat the procedure and the light will blink twice, resetting the timer to 2-1/2 minutes. Repeat again for a 3-1/2 minute interval, etc., up to a maximum of four blinks and 4-1/2 minutes.

Lock feature

Designed to prevent operation of the door from hand-held remote controls. However, the door will open and close from the Door Control, the Outdoor Key Switch and the Keyless Entry Accessories.

To activate, press and hold the Lock button for 2 seconds. The push button light will flash as long as the Lock feature is on.

To turn off, press and hold the Lock button again for

2 seconds. The push button light will stop flashing. The

The door should be fully closed the emergency release handle (so that the trolley release arm snaps into a vertical position) and lift the door manually.

The lockout feature prevents the trolley from reconnecting automatically, and the door can be raised and lowered manually as often as necessary.

TO RE-CONNECT THE TROLLEY:

if possible. Pull down on

o__--Trolley

-- Trolley Release

ArmDisconnect(in ManualPosition)

Lockout position

(Manual disconnect)

Lock feature will also turn off whenever the "learn" button

on the motor unit panel is activated.

Additional feature when used with the 3-Function

hand-held remote

Pull the emergency release handle toward the opener at an angle so that the trolley

release arm is horiflontal. The Release Handle

To control the opener lights:

trolley will reconnect on the

(Pull at 45 ° angle)

In addition to operating the door, you may program the remote to operate the lights.

1.With the door closed, press and hold a small remote button that you want to control the light.

2.Press and hold the Light button on the door control.

3.While holding the Light button, press and hold the Lock button on the door control.

4.After the opener lights flash, release all buttons.

next UP or DOWN operation, To reconnect either manually or by using the

door control or remote.

31