ASSEMBLY
Removing Unit From Carton
•Remove staples, break glue on top flaps, or cut tape at carton end and peel along top flap to open carton.
•Remove loose parts if included with unit (i.e., owner's manual, etc.).
•Cut along dotted lines and lay carton down flat.
•Remove packing material. Roll unit out of carton. Check carton thoroughly for loose parts.
Note: Make sure not to crimp the cable while removing loose parts or the unit from the carton.
IMPORTANT: This unit is shipped without gasoline or oil in the engine. Be certain to service engine with gasoline and oil before operating your mower.
NOTE: Reference to right or left hand side of the mower and/or front or behind the mower is observed from the operating position.
Loose Parts
a.Owner’s Manual
b.A Bottle of Engine Oil
c.Parts for Grass Bag: Frame, Bag
d.Discharge Chute
Tools Required
a.Pair of Pliers
b.Funnel
Disconnecting Spark Plug
•Before setting up your lawn mower, disconnect the spark plug wire from the spark plug, and ground it against the engine. See Figure 1.
•Attach rubber boot to a bolt on the engine to ground as shown below.
Spark Plug |
| Rubber Boot |
| ||
Wire |
|
|
Spark Plug
Figure 1
Assembling Handle
•Raise lower handle in direction A shown in Figure 2. It should snap into place.
Note: Make sure to route the cable inside the lower handle. Also do not crimp the cable while lifting the handle up
BUpper Handle
A
Lower Handle
Figure 2
For shipping purposes, the hairpin clip is placed in the outer hole of the weld pin on the lower handle.
•Remove the hairpin clip from the outer hole of the weld pin. See Figure 3.
Hairpin | Lower | |
Clip | ||
Handle | ||
| ||
| Weld Pin | |
| Outer Hole on | |
| Weld Pin |
Figure 3
•Using a pair of pliers, insert the hairpin clip into the inner hole in the weld pin. See Figure 3. Repeat on other side.
•Raise the upper handle in the direction B shown in Figure 2. Tighten the wing nuts which are already on the handle.
•Attach control cable to the lower handle with the cable tie already on the lower handle. Pull tight the cable tie and cut off extra. See Figure 4.
Cable Tie
Figure 4
AS SE MB LY
7
