Display Model Disassembly and | |
|
|
5.Snap chassis assembly completely into the top of the front cover (Figure
Radio Chassis
Figure 6-20. Fastening the Chassis
6.Make sure the
7.Snap the bottom of the chassis into the front cover.
8.Check that
9.After closing the radio, verify that the
10.
6.4.2.7PTT Re-assembly
1.Place the PTT seal over the ridge around the top hole. Press down to seat the seal around the ridge.
2.Place the bottom tab in the slot inside the front housing PTT opening. Slightly slide down the PTT and bow it by placing one finger under the middle of the PTT, so that the top tab can be aligned and inserted into the top slot (Figure
3.Press the PTT assembly against the front cover opening (Figure
a. Place bottom tab into bottom slot. Place top tab into top slot.
b. Push down on PTT toward bottom of radio so hooks do not get crushed.
Figure 6-21. PTT Re-assembly
HKLN4215A | December 3, 2003 |