Motorola EP450 Chassis and Front Cover Re-assembly, Main Board onto Chassis Re-assembly

Display Model Disassembly and Re-assembly:Disassembling and Re-assembling the Radio — General 6-13

.

Frequency & Volume Switches

Audio Jack Shroud

(Replace after Plugging

in Speaker and Mic)

Main Board

Interface Pad

Flex Cable Connector

Radio Chassis

Battery Contact Seal

O-Ring

Figure 6-17. Main Board onto Chassis Re-assembly

6.4.2.6Chassis and Front Cover Re-assembly

1.Dress and connect the speaker wires..

Note: Care should be taken when dressing the speaker and microphone wires to avoid pinching them between the speaker magnet and shield, or between the accessory connector and housing.

Note: Ensure that the plug orientation is correct with the exposed pins in the wire casing facing upward and fully plugged in.

a.Connect the speaker wire assembly into the 2-pin connector on the main board and bend the wires at the board connector so the wires are positioned toward the top of the radio (Figure 6-18).

b.Connect the microphone wire assembly into the two hole socket on the main board and bend the wires at the board connector so the wires are positioned toward the top of the radio (Figure 6-18).

c.Slide the audio jack shroud onto accessory connector (Figure 6-17).

HKLN4215A December 3, 2003