![](/images/new-backgrounds/1211682/211682107x1.webp)
Display Model Disassembly and | |
|
|
4.Lift the main board from the chassis (Figure
5.Remove the battery contact seal.
6.4.2Radio Re-assembly - Detailed
6.4.2.1Dust Cover Re-assembly
1.Insert the tail of the dust cap into the bottom hole of the audio jacks housing opening (Figure
2.Press the dust cap until the tail is fully into the hole.
Note: Make sure the dust cap is placed between the keypad retainer mounting post and the side wall of the radio.
3.Twist the dust cap
4.Press the cap again to ensure it fully covers the opening for the audio jack.
.
1 | 2 | 3 | 4 |
Figure 6-11. Dust Cap Re-assembly
6.4.2.2Microphone and Speaker Re-assembly
1.Check that the mic and speaker felts are in position and not damaged. If damaged replace felts.
2.Insert the microphone
3.3. Insert the Boot and microphone
HKLN4215A | December 3, 2003 |