![](/images/new-backgrounds/1211682/211682133x1.webp)
3.Remove the antenna.
4.Pry off the volume and channel selector knobs from their shafts using the knob removal/chassis opener tool (Motorola part # 6686533Z01). (Figure
Figure 7-2. Antenna and Knob Removal
Note: Both knobs slide on and off. However the knobs are designed to fit very tightly on the shaft.
5.Separate the chassis from the front housing assembly by using the knob remover/chassis opener too. Place the broad side of the opener into the slots located at the base of the radio (Figure
Knob Remover/
Chassis Opener
Radio Chassis
Figure 7-3. Chassis Removal
CAUTION: Marring the front cover
!
Note: The speaker wire assembly microphone wire assembly and keypad ribbon connector con- necting the front housing assembly and the chassis prevent the two units from being com- pletely separated
December 3, 2003 | HKLN4215A |