Using a screw-
driver,
tighten
the
screw.
Lock the cord into place by forcing it into the locking notch on the body of the quick release upper cord hook as shown. This
helps keep the power cord out
Power
Cord
Do not overtighten.
Overtightening could stdp the screw holes.
Do not operate the cleaner without
the screw in place.
CORD ASSEMBLY
Make sure the quick release upper cord hook is in the upright position. Remove the wire tie from the power cord.
HOW TO START
from under the vacuum cleaner agitator.
Wrap the power cord around the upper and lower cord hooks and lock the power cord plug onto the power cord.
Quick Releas
Upper Cord
Hook
Power
Cord
Cord
This plug will fit in a polarized outlet only
Quick Release
1. Turn the
quick
one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not
er Cordrelease upper cord hook to
either side and down to release the power cord.
2.Release the power cord plug from the power cord and pull the cord off the quick release upper cord hook. Check to be sure the power cord is still locked into the lock in the quick release upper cord hook.
3.Check to see if the cleaner has bag installed. See DUST BAG CHANGING.
NOTE: To reduce the risk of electric
shock, this vacuum cleaner has a polar- ized plug, one blade is wider than the other.
fit, contact a qualified technician to install the proper outlet. Do not change the plug in any way.
4.Plug the polarized power cord into a
120Volt outlet located near the floor.
•WARNING
Personal Injury and Product Damage Hazard
• DO NOT plug in if switch is in the ON
position. Personal injury or damage could result.
•DO NOT use outlets above counters.
Damage to items in surrounding area | I |
could occur. | i |
| I |
6