TO REMOVE DUST BAG
TO REPLACE DUST BAG
!WARNING
Always unplug power cord from elec-
trical outlet before performing any service on vacuum.
Unfold the
new dust bag. Dust Bag
Fold the safety
seal tab on the _[_._ new dust bag '/'__.t away from the
.=F--_...._ safety
Tab
Pull out on the
fitsopeningon thethatbag holder.
bag cover release located
Bag Cover _J
NOTE: See PARTS AND FEATURES for Bag number.
near the top of the bag cover.
Insert the dust bag onto the bag holder completely by holding the bag collar.
| Pull | the | bag |
| cover forward | ||
| and | lift | up. |
| Remove | and | |
Bag | lay | aside. |
Grasp the dust bag collar and pull gen- \. tly, carefully remov- ing the dust bag.
|
| /Dust |
Throw | away the | Bag |
used | dust bag. |
|
Do not reuse.
•BagHelder Check the bag holder and the
motor safety ill- ter• If either is blocked, check
- Meter |
|
Safety | TROUBLE- |
Filter | SHOOTING. |
! |
|
Tuck the bag behind each of
the four bag retention corner
flaps shown here. Be sure the bot-
tom and sides of the dust bag are completely within bag cavity prior to replacing the bag
COVer.
Close the bag cover.
Place the dust bag cellar into position.
Bag
Retention
Corner
Flaps
Position the bag cover so its
positioning tabs fit into the body
positioning tab
slots.
CAUTION |
NEVER REUSE A DUST BAG. Very fine materials, such as carpet fresh- ener, face powder, fine dust, plaster,
soot, etc. can clog the bag and cause it to burst before it is full.
Change bag more often when vacu- uming these materials.
You will hear a
distinct snap when cover _s
securely closed.
Check to see that the dust bag
is fully enclosed in the bag cover.
14