REMOVING THE CONSOLE & THE
TOUCHPAD SUBASSEMBLY
WARNING
Electrical Shock Hazard Disconnect power before servicing. Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
1.Unplug dryer or disconnect power.
2.Turn off gas supply to dryer.
3.Pull the dryer away from the wall and remove the top cover (see steps 4 and 5 on page
4.Remove the three screws from the elec- tronic control board bracket, and tip the bracket assembly inside the dryer (see step 6 on page
5.Disconnect the ends of the two ribbon cables from the electronic control board connectors P3 and P4.
6.Remove the two screws from the console bracket.
Console Bracket Screws
7.Open the door and pull out on the bottom of the console to release the locking tabs from the door panel.
8.Lift the console straight up until the brack- ets are free of the left and right side panel flanges and remove the console.
Viewed From Back Of Console
Lift Console Bracket From
Flange On Both Sides
Side Panel Flange
P4 P3
Electronic
Control
Board
Press In On Clips To
Release Cables
