Whirlpool MED / GD 9600S, MED / GD 9700S manual To remove the belt switch

g)Lift the top locking tab of the motor harness plug and pull the top pins away from the motor connector, then release the bottom tab, and remove the plug.

9.To remove the belt switch:

a)Remove the 3/8 inch hex shoulder- washer screw from the idler pulley as- sembly and remove the assembly.

Top Locking Tab

Motor Harness Plug

3/8 inch Hex Shoulder Washer Screw

Idler Pulley Assembly

b)Remove the two screws from the belt switch and remove it from the motor.

h)Remove the two hex washer-head mounting screws from the drive motor, then lift the right side of the motor slightly, pull the two tabs on the left side out of the chassis slots, and remove the drive motor.

Hex Washer-Head Screws

Belt Switch Screws

c)Disconnect the blue wires from the belt switch terminals.

Blue Wire Blue Wire

Belt Switch

4-9