Whirlpool MED / GD 9700S, MED / GD 9600S manual To remove the heater

REMOVING THE HEATER, THE HIGH-LIMIT

THERMOSTAT, & THERMAL CUTOFF

(ELECTRIC DRYERS ONLY)

WARNING

Electrical Shock Hazard Disconnect power before servicing. Replace all parts and panels before operating.

Failure to do so can result in death or electrical shock.

1.Unplug dryer or disconnect power.

2.Remove the two hex-head screws from the bottom flange of the toe panel. Pull the panel out at the bottom, pull down, and remove the panel.

3.Remove the hex-head screw from the heater shield and remove the shield.

Heater

Shield

Screw

4.To remove the heater:

a)Remove the two wires from the termi- nal block (see photo in step 5).

b)Remove the hex-head screw from the heater housing, and slide the heater out of the duct.

Toe Panel

Toe Panel Screws
		Heater Housing
		Screw
	High-Limit Thermostat,
	Thermal Cutoff, & Heater Area

4-10