Whirlpool MED / GD 9700S, MED / GD 9600S manual Removing the BELT, DRUM, & Rollers

REMOVING THE BELT, DRUM, & ROLLERS

WARNING

Electrical Shock Hazard Disconnect power before servicing. Replace all parts and panels before operating.

Failure to do so can result in death or electrical shock.

1.Unplug dryer or disconnect power.

2.Turn off gas supply to dryer.

3.Pull the dryer away from the wall and remove the top cover (see steps 4 and 5 on page 4-2 for the procedure).

4.Remove the console (see page 4-4 for the procedure).

5.Remove the lint duct (see steps 3 through 6 on page 4-7 for the procedure).

6.Reach around behind the drive motor and push the idler wheel arm to the left, then remove the tension, and remove the belt from the idler pulley.

Remove Belt

From Idler Pulley

7.Disconnect the 3-wire moisture sensor con- nector from the main harness connector.

Moisture Sensor

Connector

8.Disconnect the 3-wire door switch con- nector from the electronic control board connector.

3-Wire

Door Switch

Connector

9.Loosen the two top front panel screws.

Top Front Panel Screws

Push To Left

10. Remove the two bottom front panel screws.

Bottom Front Panel Screws

4-12