2-8

Connect ground wire (green or bare) of power supply cord t o
external ground conductor screw. T ighten sc rew.
Co nnect t he other w ires to ou ter ter m in al bl ock screw s .
Tighten screws .
Tighten strain rel ief screws .
Insert tab of terminal block cover into slot of dryer rear panel.
Secure cover with hold-down screw.
You have completed your electrical connection. Now go to
“Venting Requirements.”

1234567896849745687345677

A 4-wire connection is required for mobile homes
and where local codes do not permit the use of 3-wire
connections.
Direct wire cable must have 5 ft (1.52 m) of extra length so dryer
ca n be m ove d if ne eded.
Strip 5" (12 .7 cm ) of ou ter co ver in g fr om en d of cab le, le avin g
bare ground wire at 5" (12.7 cm). Cut 1 / " (3.8 cm) from
3 remaining wire s. St rip insula tion back 1" (2.5 cm). Sha pe ends
of wires into a hook shape.
When connecting t o the terminal block, pl ace the hooked end of
the wire u nder the scr ew of the terminal block (hook facing right),
squeeze hooked end together and tighten screw, as shown.
R em ove cente r s ilver-colo r ed ter m in al bl ock screw.
Remove neutral ground wire from external ground conductor
screw. Connect neutral gro und wire and place the hooked
end (hook facing right) of the n eutral wire (wh ite or center
wire) of direct wire cable under the center screw of the
terminal block. Squeez e hooked ends t oget her. Tighten
screw.