Whirlpool MED / GD 9700S, MED / GD 9600S 42Connect the other wires to outer terminal block screws

When connecting to the terminal block, place the hooked end of the wire under the screw of the terminal block (hook facing right), squeeze12 hooked end together and tighten screw, as shown.

3Loosen or remove center silver-colored terminal block screw.

Place the hooked end of the neutral wire (white or center wire) of direct wire cable under the center screw of terminal block (hook facing right). Squeeze hooked end together. Tighten screw.

￿￿123234567896￿￿!2"￿￿￿￿￿#￿￿8567579579￿7776￿￿￿￿￿￿8$￿￿￿￿5￿￿76￿8￿￿￿￿7￿￿67￿89￿￿￿￿￿￿￿￿76￿796￿58567￿76￿￿6%￿￿￿76￿

42Place the hooked ends of the other direct wire cable wires under the outer terminal block screws (hooks facing right).

52Squeeze hooked ends together. Tighten screws.

6Tighten strain relief screw.

Insert tab of terminal block cover into slot of dryer rear panel.

7Secure cover with hold-down screw.

You have completed your electrical connection. Now go to “Venting Requirements.”

12￿￿89￿123456789￿￿￿￿￿￿￿￿￿￿2￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿4 9￿￿￿566￿￿34569￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿ ￿￿￿9￿

3Remove center silver-colored terminal block screw.

Remove neutral ground wire from external ground conductor screw. Connect neutral ground wire and the neutral wire (white or center wire) of power supply cord/cable under center, silver-colored terminal block screw. Tighten screw.

￿￿6￿32&'7345678￿￿8567￿!2"￿￿￿￿￿#578￿￿￿8￿￿6776(95￿￿￿￿$￿￿￿￿5￿6567￿￿86￿￿￿)￿9￿76￿￿￿8￿￿￿￿567579￿￿5￿56789￿￿￿6%76*￿￿￿￿9￿￿76%￿6￿￿￿6￿6￿57￿￿￿98

42Connect the other wires to outer terminal block screws.

52Tighten screws.

6Tighten strain relief screws.

Connect a separate copper ground wire from the external

7ground conductor screw to an adequate ground.

Insert tab of terminal block cover into slot of dryer rear panel. Secure cover with hold-down screw.

2-10