TROUBLESHOOTING
Problem | Possible Cause(s) | Corrective Action | ||
|
|
|
|
|
Engine fails to start | 1. | Fuel tank empty or stale fuel. | 1. | Fill tank with clean, fresh gasoline. Fuel will not |
|
|
|
| last over thirty days unless a fuel stabilizer is |
|
|
|
| added. |
| 2. | Spark plug wire disconnected. | 2. | Connect wire to spark plug. |
| 3. | Cannot pull recoil cord. | 3. | Obstruction lodged in impeller. Disconnect |
|
|
|
| spark plug wire and remove lodged object. |
| 4. | Choke not in ON position. | 4. | Move CHOKE to ON position. |
| 5. | Faulty spark plug. | 5. | Clean, adjust gap or replace. |
| 6. | Safety switch not depressed. | 6. | Safety switch must be depressed by the front |
|
|
|
| tab on the bag handle when securing the bag. |
| 7. | Safety switch wire is not | 7. | Connect safety switch wire to engine connector |
|
| connected to engine or not |
| and ground to mounting bracket. |
|
| properly grounded. |
|
|
|
|
|
|
|
Loss of power; | 1. | Spark plug wire loose. | 1. | Connect and tighten spark plug wire. |
operation erratic | 2. | Unit running on CHOKE. | 2. | Move choke lever to OFF position. |
| 3. | Blocked fuel line or stale fuel. | 3. | Disconnect fuel line at carburetor to drain fuel |
|
|
|
| tank; fill tank with clean fresh gasoline. Fuel will |
|
|
|
| not last over thirty days unless a fuel stabilizer is |
|
|
|
| used. |
| 4. | Water or dirt in fuel system. | 4. | Disconnect fuel line at carburetor to drain fuel |
|
|
|
| tank. Refill with fresh fuel. |
| 5. | Carburetor out of adjustment. | 5. | Contact your Sears Parts & Repair Center. |
| 6. | Low engine RPM. | 6. | Always run engine at full throttle. |
|
|
|
|
|
Too much vibration | 1. | Loose parts or damaged | 1. | Stop engine immediately and disconnect spark |
|
| impeller. |
| plug wire. Have unit serviced by a Sears Parts & |
|
|
|
| Repair Center. |
|
|
|
|
|
Engine overheats | 1. | Carburetor not adjusted | 1. | Contact your Sears Parts & Repair Center. |
| 2. | Engine oil level low | 2. | Fill crankcase with proper selection of oil. |
|
|
|
|
|
Unit does not | 1. | Discharge area clogged. | 1. | Stop engine immediately and disconnect spark |
discharge |
|
|
| plug wire. Clean flail screen and inside of |
|
|
|
| discharge opening. See Maintenance section of |
|
|
|
| this manual. |
| 2. | Foreign object lodged in | 2. | Stop engine immediately and disconnect spark |
|
| impeller. |
| plug wire. Remove lodged object. |
| 3. | Low engine RPM. | 3. | Always run engine at full throttle. |
| 4. | Vacuum bag is full. | 4. | Empty bag. |
|
|
|
|
|
Rate of discharge | 1. | Low engine RPM. | 1. | Always run engine at full throttle. |
slows considerably or | 2. | Chipper blade dull. | 2. | Replace chipper blade or see your Sears Parts |
composition of |
|
|
| & Repair Center. |
discharged material |
|
|
|
|
changes |
|
|
|
|
|
|
|
|
|
Unit fails to propel | 1. | Drive control cable out of | 1. | Follow adjustment procedure in Service and |
itself or slips when |
| adjustment. |
| Adjustments section of manual. |
drive control is | 2. | Drive belt worn or damaged. | 2. | Contact your Sears Parts & Repair Center. |
engaged |
|
|
|
|
|
|
|
|
|
NOTE: For repairs beyond the minor adjustments listed above, please contact your local Sears Parts & Repair Center.
19
