Craftsman 247.797852 Enginespeed, Idle Speed Stop Adjusting Screw Throttle Needle Valve, First

•Test the engine by using the chipper-shredder If engine tends to stall or die out, it usually indicates that the mixture is slightly lean and it may be nec- essary to open ( _ ) the needle valve slightly to provide a richer mixture This richer mixture may cause a slight unevenness in idling

	Throttle
Idle Speed	Stop
Adjusting Screw

Throttle

Needle Valve

FIGURE 22.

ENGINESPEED

Your engine speed has been factory set Do not attempt to increase engine speed or it may result in personal injury, If you believe the engine is running too fast or too slow, take your chipper-shredder to the

nearest SEARS Service Center for repair and adjust- ment,

SERVaCE RECOMMENDATIONS

SERVICERECORDSCHEDULESERVICE DATES

Fill in dates as you complete regular service

			First	Before	Every	Every	Begin-	Before
			5	Each	25	50	ning Each	Storage
			Hours	Use	Hours	Hours	Season
Check	Fuel			,]
Drain	Fuel
Check	Engine Oil Level			,1
Change		Engine	Oil		.j
Oil Pivot		Points
Service		Air Cleaner			V
Clean	Engine Cylinder Fins				,l		,/
Replace or Clean Spark Plug						,/		,]
Spark	Arrester		Muffler			V

The Service Recommendations Chart is supplied to assist the operator in proper maintenance of the chip- per-shredder, This is only a check list; instructions will be found in the Maintenance and Service Adjustment sections of this manual

15