Craftsman 247.797853, 247.797852 manual Howtoset-Upyourchipper-Shredder

Bolt

Chute

Deflector

Hex

Nut ,.

Knob

J

\/

/

FIGURE 2,

Stop

Washer

Upper

Guide

			Release	Assembly
			Bar
/			8-3/8" Long
			Flat Washer
			Hex Lock Nut
FIGURE	3.
	Hopper	Pivot		ly
	Door
ASSEMBLE THIS		\
TRUSS SCREW
AND NUT FIRST
				Leaf
Release"				Ramp
Bar				Section
			Remove Truss
			Screw and Nut
			Guide
		Assembly
FIGURE	4.
			Drawstring
				/

FIGURE 5.

HOWTOSET-UPYOURCHIPPER-SHREDDER

MAKE CERTAIN THE SPARK PLUG]

WIRE IS DISCONNECTED AND MOVED /

AWAY FROM THE SPARK PLUG /

BEFORE ASSEMBLING THE CHIPPER- /

SHREDDER.j

_"-ATTACHINGTHE HOPPER ASSEMBLY

eRemove the hand knobs and cupped washers from each side of the discharge opening on the left side

of the chipper-shredder

e Remove hex lock nut, two spacers and hex bolt from inside the hinge on top of the discharge open-

ing Do not remove one spacer from the hex bolt. e Place the chute deflector in position on the dis-

charge opening Insert hex bolt and spacer'through hinge on chute deflector and housing (spacer fits inside of hinge) See figure 2.

e Place second spacer over hex bolt, inside other part of hinge Secure with hex lock nuL Tighten securely.

®Secure both sides of chute deflector to housing using hand knobs and cupped washers (cupped side of washers go against chute deflector)

"<,-ATTACHINGTHE UPPER GUIDE ASSEMBLY

Place upper guide assembly in position on frame, making certain edges of the upper guide assembly are underrreath stop washers, and the release bar is in the slots. See figure 3 Insert hex bolt 8-3/8" long through upper guide assembly and frame_ Secure with flat washer and hex lock nut

NOTE: Make certain upper guide assembly can pivot by pulling up on release bar and lowering upper guide assembly If necessary, loosen hex lock nut a turn or

two Put the upper guide assembly back into the raised position

"<_-ATTACHING THE HOPPER ASSEMBLY

Your chipper-shredder has been shipped with the upper leaf ramp section attached to the hopper assembly. See figure 4. Attach the hopper assembly to the upper guide assembly as follows Be certain to place heads of all truss machine screws inside of hopper assembly.

®Remove one truss machine screw and nut from each side of hopper assembly as shown in figure 4. Push hopper pivot door down inside lower part of hopper as you place hopper assembly (both pieces) inside upper guide assembly Replace truss screws and nuts just removed, using the hote shown in figure 4, one on each side. Tighten finger

tight only.

e Place the six truss machine screws and nuts found in hardware pack in the remaining holes of hopper assembly, alternating sides of the unit and tighten- ing finger tight only.

®After' assembling all eight screws, tighten them securely.

"<-ATTACHING THE CATCHER BAG

Your chipper-shredder is equipped with a catcher bag to catch the shredded material

6