Diamondback PM4360 manual Assembly Notes, Response Er6c

Response Er6c

Assembly Hardware Kit / Ensemble du matériel de montage

DP # / DP nº #22-10-1254

14mm / 19mm Box Wrench and Phillips Screwdriver Combination Tool

Outil combinant une clé polygonale 14 mm/19 mm et un tournevis cruciforme

(1)

3.0 mm, 4.0 mm, 5.0 mm & 6.0 mm Hex Key Set Ensemble de clés hexagonales de 3,0 mm, 4,0 mm, 5,0 mm et 6,0 mm

(1)

Assembly Notes

•Please read the entire Response Er6c Owner’s Manual before beginning the assembly. Review the package contents to ensure all listed parts are included.

•The assembler will require 14 mm & 18 mm box wrenches, 6 mm, 5 mm, 4 mm & 3 mm hex wrenches, and a Phillips screwdriver for assembly. All required tools are included.

•The estimated assembly time of the Response Er6c by a person familiar with basic tool usage is forty- five (45) to sixty (60) minutes.

•Always inspect the unit to ensure handlebars and steparms are tightened prior to using the unit.

ASSEMBLY INSTRUCTIONS 1

B

C-4 C-2

C-1

C-3

B-3 C-24

C

C-23

Install the four (4) stabilizer feet (C-23).

Remove the eight (8) hex fixing bolts (C-2)and 16 washers (C-4,C-3 & C-1)from the console mast (B) and and set aside.

While supporting the console mast (B) and the rear frame (C), connect the lower connector of wire (B-3)with connecter (C-24). Ensure the connections are solid.

Carefully insert rear frame (C) into the receiver of the console mast

(B)taking care not to pinch the wire harness. Align the holes in the console mast receiver with the bolt holes of the rear frame and re- install bolts (C-2), curved washers (C-4), flat washers (C-1)and lock washers (C-4).

Level the unit. If viewed from above, turn the knobs clockwise to raise the feet and counter-clockwise to lower them.

7