Diamondback PM4360 manual Final Setup & 6 Installation

A-1

B-11 B-3 B-1

A-2

A-2 A-6 A-5

B-13

N

The console hinge cover (A-1) is installed	5
onto the console at the factory. Remove the

Afour (4) screws (A-2) from the back of the console hinge cover (A-1) and set the parts aside. Four (4) more A-2Phillips screws will now be visible on the backside of the console. Remove these, and set aside.

While supporting the console (A), feed wire connectors A-6& A-5through inside of the console hinge cover A-1and join connector A-6with connector B-11. Join connectors A-5and B-3. Make sure all connections are solid. Slide the console hinge cover A-1downward on the cable to rest on the console mast.

Tilt the console hinge (B-1) to its most upright position and feed the four (4) screws (A-2) through the under side of the console mounting plate (B-1) and into the back of the console (A). Only the upper and lower holes of the hinge plate are used in this step. Tighten firmly.

Align console hinge cover (A-1) with the

backside of the console, taking care to

tuck the wires into the backside of the

console or into the console mast.

Feed the four (4) screws (A-2)

through the back side of the

console hinge cover and into the

console. Tighten firmly.

Connect the power supply (N) to

a 120 Volt power source. Insert

C-28 the opposite end into the power input jack (C-28).

FINAL SETUP & 6 INSTALLATION

Move the unit into final position with the help of the front transport rollers. This unit is heavy. Safe transport may require more than one person. Carefully lift and support the rear end of the unit until both wheels touch the ground. Slowly roll into position.

After moving the unit, ensure all four feet are touching the floor. Review assembly step #1 above for leveling instructions.

Inspect the unit for loose bolts, hardware, knobs or pins.

Plug the AC adaptor in a 120 Volt power supply. Plug the opposite end into the input jack found at the rear of the unit

(CC).

9