2 34

 

B-20

 

 

 

 

B-21

 

H-L

H-R

B-14

B-16

 

 

 

 

 

 

 

G-15 G-1 G-14

 

B-33

 

 

G-R

 

B-27

B-25

H-R

 

 

B-26

 

G-L

 

 

 

 

 

B-19

H-L

 

 

 

 

 

 

 

Parts B-14,B-16,B-19,B-19,B-20 & B-21

Parts B-33,B-27,B-26 &

The forward pivots of steparm G-L&

will arive from the factory pre-assembled in the

B-25will arive from the factory

G-Rwill arive from the factory with

carton. Disassemble by removing bolts B-14

pre-assembled on the console

parts G-15, G-1& G-14pre-installed.

and B-21from parts B-16, B-19& B-20.

mast. Remove all components

Remove bolts G-14, pivot caps G-1&

Gather the left (B-19)and right (B-20) lower

except B-25and set aside.

washers G-15from the steparms and

console mast covers and bring together as a

Slide the left (H-L) and right

set aside.

clamshell over the console mast/main frame

Bring the pivots of the left step arm

(H-R) handlebar assemblies

union. Align covers with the mounting holes

over the upper pivot. The fit is

(G-L) and handlebar (H-L) together,

and loosely thread the four (4) hex bolts B-21

sliding the handlebar pivot over the

into place. Do not tighten yet.

designed to be tight so proper

step arm pivot axle and press into

Positon the lower console mast front cover

alignment is necessary for

place.

installation.

(B-16) in place and thread the four (4) hex

Re-install washer G-15, pivot cap G-1

 

bolts (B-14) through the face and into parts

Re-install washers B-26,pivot

and fixing bolt G-14. Tighten firmly.

B-19and B-20. Do not over-tighten.

caps B-27and fixing bolts

Repeat for right-hand side.

Align and tighten all bolts. Do not over-tighten.

B-33. Tighten bolt B-33firmly.

8

Page 8
Image 8
Diamondback PM4360 manual Forward pivots of steparm G-L