ASSEMBLY
4.Position the chute assembly over the base. See Figure 3.
5.Close the flange keepers to secure the chute assembly to the chute base. See Figure 4. The flange keepers will click into place when properly secure.
NOTE: If the flange keepers will not easily click into place, use the palm of your hand to apply swift, firm pressure to the back of each.
6.a. Remove the flat washer and hairpin clip from the end of the chute directional control.
b.Insert the end of the chute directional control into the lower bracket and secure with the flat washer and hairpin clip just removed. See Figure 5. If necessary, the lower bracket can be adjusted. Refer to Chute Bracket Adjustment in the Service & Maintenance section.
Figure 3
Figure 4
Figure 5
