Craftsman 315.115042 AUXILLeIRY, INSTALLING SANDING DISC Disconnect sanderfrom power supply

INSTALLING SANDING DISC

•Disconnect sanderfrom power supply,

•Assemble parts as shown in Figure 9.

•Place washer on spindle,then thread rubber back-up pad onto spindle.Lock spindleby depressing spindle lock buttonand handtighten beck-up pad.

•Positionback-up disc and sanding disc in place and threadflange nut onto spindle.Tighten flange nut securely byturning the sandingdisc clockwiseby hand.

,_	WARNING:	Use only the back-up pad and back-
	up disc supplied with your tool, Other types of pads		AUXILLeIRY
	or discscould disintegrate causing possible sedous
			HANDLE
	personalinjury.
SANDING
See Figure 10,
The matedal being sanded shouldbe held firmly,Secure
smallworkpiece in a vise or clamp to workbench.
Hold your sander in front and away from you with both
hands. With the sendingdisc clear of the workpieca, start
your sander and letthe motor reach its maximum speed,
then lowerto the work surface at a slight5 to 8 degree
angle. See Figure 10. Do not allow the tool to remain in
one place, This willcause uneven sandingor gougingof
the work. Keep your sander slowly movingover the work.
_l,	WARNING:	Keep a firm grip on the handles of your
	tool with both hands at all times, Failure to do so
	could result in loss of control leadingto possible		FLANGENUT
	seriousinjury,
This toolwas designed sothat the weight of the tool alone			Fig. 9
will provideadequate weight on the sandingdisc. Extra			_, WARNING: Always wear protectivegoggles.
pressurewill only result in unevenwork, slowersanding
			Sparks, wire and loose particlescan be thrown
from slower speed, and possiblemotor bum-out,
			while using a wire brush. Use of your sander
Upon completionof work, or a sending operation,lift your
			without gogglescould result in serious personal
sander away from work surface beforeturning off.
			injuwy.
_lh	WARNING:	Sanding disc must come to a
	complete stop before setting tool down on
	workbench, Failureto do so can cause the tool to
	be thrown from workbench because of sending disc

rotation.This could result in damage to the tool or possible sedous personal injury,

To remove paint, varnish, or rust, send with an opankote type sandingdisc.

Another method of removingpaint or rust is by wire brushing,The wire cup brush may be threaded directly ontothe spindle,

Fig. 10