GE GNPR40L Plan HOW YOU will Install Softener, Optional 3-VALVE Bypass Installation Illustration

Installation Instructions

PLAN HOW YOU WILL INSTALL

THE SOFTENER

You must first decide how to run the inlet and outlet pipes to the softener. Look at the house main water pipe at the point where you will connect the softener. Is the pipe soldered copper, glued plastic or threaded galvanized? What is the pipe size?

WARNING: Use only lead-free solder and flux to prevent lead poisoning.

See Typical Installation Illustration. Use this as a guide when planning your particular installation. Be sure to direct the incoming hard water supply to the softener valve inlet fitting. The valve is marked

IN and OUT.

TYPICAL INSTALLATION ILLUSTRATION
Hard water	MAIN	WATER
Hard water to		PIPE
outside faucets		Soft
12V		water
transformer
120-volt
outlet
		Pipe coupler
		Union nut
	Adapter
OUTLET		Brine line
Brine
tank cover

OPTIONAL 3-VALVE BYPASS

INSTALLATION ILLUSTRATION

Hard water to outside faucets

	Hard water		MAIN	WATER
				PIPE
12V				Soft
	120-volt	Bypass		water
transformer outlet		valve		Outlet
		Inlet		valve
		valve

Pipe coupler

Union nut

Adapter

OUTLET Brine line

SALT
GOES
HERE		NOTE: See
		Drain Hose
Brinewell		Connections
		section.
Fig. 1	CROSSOVER
Use if water supply flows
from the left. Include single
	or 3-valve bypass.
Soft
water
	Hard
	water
To softener
inlet	From
	softener
	outlet

Brine tank cover

SALT

GOES

HERE

Brinewell

Fig. 2

CROSSOVER

Use if water supply flows from the left. Include single or 3-valve bypass.

Soft water

Hard water

To softener inlet

From softener outlet

3-Valve Bypass System

For soft water service:

•Open the inlet and outlet valves

•Close the bypass valve

For bypass hard water:

•Close the inlet and outlet valves

•Open the bypass valve

5