Installation Instructions
PROGRAMMING THE CONTROL
PROGRAMMING THE CONTROL
The green indicator lights up next to the name of the active control setting.
Pressing the DOWN 
button displays the settings in order. By continuing to press the DOWN 
button, the settings start over, beginning with the time of day. Pressing the UP 
button displays the settings in reverse order.
To change the settings, press the SET button on
the top right. A digit on the display will start to flash. If you want to change this number, press the UP 
button to increase the number or the DOWN 
button to decrease the number.
When the number is correct, press the LEFT 
button. The digit to the right will stop flashing and the next digit to the left starts flashing.
To skip the number without changing, press the LEFT 
button. When you reach the far left digit, press
the LEFT 
button to return to the digit on the right.
NOTE: If you press and hold either the UP 
or DOWN 
button for more than 1 second, the flashing number will increase or decrease at ten counts per second.
You can only change the flashing digit. Continue changing numbers until you reach the desired setting. Press the SET button. The numbers stop flashing and the control accepts the new settings. After approximately 30 seconds, the control starts alternating the display between TIME OF DAY and
CAPACITY.
NOTE: If the new setting is not accepted because it was outside the allowable range, the old value will be displayed. Refer to the table guides for correct settings.
SET PRESENT TIME OF DAY
PM Indicator light
Press UP 
or DOWN 
button to select TIME OF DAY.
1.Press the SET button. The display will show the time of day with the minutes blinking.
2.Press UP 
or DOWN 
button to set. The UP button advances the digit; the DOWN button moves the digit in reverse.
When the number is correct, press the LEFT 
button. The digit to the right will stop flashing and the next digit to the left starts flashing. You can only change the flashing number.
If the present time is between noon and midnight, be sure PM indicator light is on. If the present time is between midnight and noon, be sure PM indicator light is off.
To change AM/PM, advance the far left digit. The digit will alternate between 0 and 1. As the digit alternates, the PM light will turn on and off.
NOTE: Each press of an UP 
or DOWN 
button changes the digit by one minute. Holding the button changes the digit at a rapid rate.
3.When the present time is correct, press SET to accept.
11
