TO ADJUST DEPTH OF CUT FOR FIXED BASE ROUTERS

See Figures 12, 13, and 14.

Follow these steps to adjust depth of cut for fixed base routers.

1, Unplug the router,

,_ WARNING: Failure to unplug the tool could result in sedous injury due to accidental starting.

2.Place the router on a flat surface.

3.Loosen the lockingarm.

4.Turn the depth adjustment ring counterclockwise until the tip of the cutter touchesthe flat surface.

5.Turn the depth indicator ring until the zero lines up

LOCKING

ARM

Fig. 12

with the indicator point on the base.

6.Position the router so that the cutter can extend below the subbase for desired depth of cut.

7.Turn the depth adjustment ring to obtain the desired depth of cut.

POINT IN__

RING

Fig. 13

8.Tighten the locking arm securely.

Note: To adjust the depth of cut when the router is mounted to a router table, turn the depth adjustment ring untilthe cutter reaches the desired depth of cut.

Fig, 14

14

Page 14
Image 14
Craftsman 315.175341 operating instructions To Adjust Depth of CUT for Fixed Base Routers, Locking ARM, Point Ring