POSITIVE STOPS ON MITER TABLE
Positive stops have been provided at 0°,
_w
173/16"
l
BEVEL LOCK KNOB
The bevel lock knob securely locks your compound miter saw at desired bevel angles. Positive stop adjustment screws have been provided on each side of the saw arm. These adjustment screws are for making fine adjustments at 0°and 45°. See pages 17 and 18.
ELECTRIC BRAKE
An electric brake has been provided to quickly stop
blade rotation after the switch is released.
103/16"
___7tt6"DIAHOLE
173/16"
24"
313_"
Fig. 7
MITER FENCE
The miter fence on your compound miter saw has been provided to hold your workpiece securely against when making all cuts; the left side is also larger providing additional support. It has a sliding feature for clearance of the saw arm when making bevel or compound cuts.
Loosen the fence screw before attempting to slide the miter fence. Once the desired position of the miter fence is determined, tighten the fence screw to secure the sliding fence.
SELF-RETRACTING LOWER BLADE GUARD
The lower blade guard is made of
MOUNTING HOLES
See Figure 7.
Your compound miter saw should be permanently mounted to a firm supporting surface such as a workbench. Four bolt holes have been provided in the saw base for this purpose. Each of the four mounting holes should be bolted securely using 3/8 in. machine bolts, lock washers, and hex nuts (not included). Bolts should be of sufficient length to accommodate the saw base, lock washers, hex nuts, and the thickness of the workbench.
Tighten all four bolts securely.
The hole pattern for an 18 in. x 24 in. workbench is shown in Figure 7. Carefully check the workbench after mounting to make sure that no movement can occur during use. If any tipping, sliding, or walking is
noted, secure the workbench to the floor before
operating.
_, WARNING: Always make sure your compound miter saw is securely mounted to a workbench or
an approved workstand. Failure to do so could result in an accident resulting in possible serious
personal injury.
ELECTRICAL CONNECTION
Your saw has a precision built electric motor. It should be connected to a power supply that Is 120 volts, 60Hz, AC only (normal household current). Do not operate this tool on direct current (DC). A substantial voltage drop will cause a loss of power and the motor will overheat. If your tool does not operate when plugged into an outlet,
A WARNING: The operation of any saw can result in foreign objects being thrown into your eyes, which can result in severe eye damage. Before starting power tool operation, always
wear safety goggles or safety glasses with side shields and a full face shield when needed. We
recommend wide vision safety mask for use over
eyeglasses or standard safety glasses with side shields.
_i, WARNING: Do not attempt to modify this tool or create accessories not recommended for use
with this tool. Any such alteration or modification is misuse and could result in a hazardous
condition leading to possible serious personal injury.
12
