ATTACHINGGRASSDEFLECTOR
See Figure 2 - 3, page L
_IL WARNING: The line
[] Remove supplied screws with a phillips screwdriver from the trimmer head.
[] Fit the grass deflector onto the raised posts on the trimmer head.
NOTE: The deflector should be flush to the trimmer head.
[] Install supplied screws and tighten by turning clock- wise with a phillips screwdriver.
A WARNING: Do not allow familiarity with this product to make you careless. Remember that a careless fraction of a second is sufficient to inflict serious injury.
TO INSTALL BATTERY PACK
See Figure 5, page i.
[] Insert the battery pack into the product as shown.
[] Make sure the latches on each side of the battery pack snap into place and the battery pack is secured before
A
WARNING: Always wear eye protection with side shields marked to comply with ANSI Z87.1. Failure to do so could result in objects being thrown into your eyes, resulting in possible serious injury.
beginning operation.
TO REMOVE BATTERY PACK
See Figure 5, page i.
[] Depress the latches on each side of the battery pack.
A WARNING: Never use blades, flailing devices, wire, or rope on this product. Do not use any attachments or accessories not recommended by the manufacturer of this product. The use of attach- ments or accessories not recommended can result in serious personal injury.
This product will accept Craftsman _ 19.2 V
For complete charging instructions, refer to the Operator's Manual for the battery packs and chargers listed in the
IMPORTANT SAFETY INSTRUCTIONS.
BATTERY PROTECTION FEATURES
Craftsman _°19.2 V
If the tool stops during use, release the trigger to reset and resume operation. If the tool still does not work, the battery needs to be recharged.
STARTING/STOPPING THE STRING TRIMMER See Figure 4, page L
[] To start the string trimmer, push the
[] To stop the string trimmer, release the switch trigger.
[] Remove the battery pack.
TELESCOPING BOOM
See Figure 6, page i.
The boom can be extended or shortened for ease of use. [] Remove the battery pack.
[] Loosen thetelescoping boom coupler byturning it coun- terclockwise. Slide the boom to the desired position.
[] Tighten the coupler by turning clockwise. Make sure the boom is securely tightened before reinstalling the battery pack.
ADJUSTABLE FRONT HANDLE
See Figure 7, page ii.
The angle of the front handle can be adjusted 180°. [] Remove the battery pack.
[] Set the trimmer on a flat surface and turn the knob coun- terclockwise to loosen the handle.
[] For trimming, adjust the handle upward.
[] For edging, adjust the handle downward.
[] Turn the knob clockwise until the handle is securely tightened before reinstalling the battery pack.
7 - English