ASSEMBLY
IMPORTANT: This unit is shipped without gasoline or oil in the engine. After assembly, see OPERATION section of this manual for proper fuel and engine oil
NOTE: Reference to right or left hand side of the cultivator / edger is observed from the operating position.
Removing Unit From Carton
•Remove staples, break glue on top flaps, or cut tape at carton end and peel along top flap to open carton.
•Remove all loose parts that may be included with unit.
•Cut along corners, lay carton down flat, and remove packing material.
•Roll or slide unit out of carton and check carton thoroughly for loose parts.
Loose Parts In Carton
•Operator’s Manual
•3.4 fl.oz. (100ml) Bottle of Engine Oil
•Edger Wheel
•Edger Blade
Disconnecting Spark Plug
Before setting up your cultivator / edger, disconnect the spark plug wire from the spark plug and ground to a stud on the engine.
Marked |
| ||
Lines |
|
| |
| Carriage |
| |
| Bolt |
| |
Wing Nut | Lower Handle | Upper Handle | |
Connector | |||
| Connector | ||
|
| ||
Figure 1
Setting Up Your Cultivator / Edger
•Loosen each wing nut enough to separate the plastic connectors between the upper and lower handle. Gently lift up and pull out on the upper handle to raise the handle toward the operating position. See Figure 1.
•Separate the connectors and position the bottom tip of upper handle connector in front of the bottom tip of lower handle connector.
•The lower handle connector has three marked lines on the top and the upper handle connector has one marked line.
•Position the connectors aligning the marked line on the upper connector with the middle marked line on the lower connector.
•To secure the upper and lower handle, tighten the wing nuts and washers (carriage bolts must be seated properly into the outer handle and grooves must line up between connectors).
•If not already, tighten the cable tie on the right side of handle.
5
