Craftsman 316.2927 manual Troubleshooting, Problem, Cause, Remedy

Models: 316.2927

1 36
Download 36 pages 29.9 Kb
Page 13
Image 13
TROUBLESHOOTING

TROUBLESHOOTING

Problem

 

Cause

 

Remedy

 

 

 

 

 

Engine fails to start

1.

Spark plug wire disconnected.

1.

Connect wire to spark plug.

 

2.

Ignition switch is OFF (O).

2.

Turn switch to ON (I).

 

3.

Fuel tank empty or stale fuel.

3.

Fill tank with clean, fresh gasoline.

 

4.

Primer bulb wasn’t pressed enough.

4. Press primer bulb fully and slowly 5-7

 

 

 

 

times.

 

5.

Engine flooded.

5.

Use starting procedure with choke lever

 

 

 

 

in the Open (C) position.

 

6.

Faulty spark plug.

6.

Clean, adjust gap, or replace.

Engine flooded

1.

Too much gasoline primed through

1.

With the choke lever in the Open (C)

 

 

engine.

 

position.

 

 

 

2.

Squeeze the throttle control to the wide

 

 

 

 

open position.

 

 

 

3.

Place right foot on the right side of

 

 

 

 

cultivator wheel.

 

 

 

4.

Pull the starter rope briskly 3 to 5 times

 

 

 

 

or until engine starts.

 

 

 

5.

With tines off the ground, depress the

 

 

 

 

throttle lever against the upper handle

 

 

 

 

to increase engine speed and rotate

 

 

 

 

tines.

Engine runs erratic

1.

Spark plug wire loose.

1.

Connect and tighten spark plug wire.

 

2.

Blocked fuel line or stale fuel.

2.

Clean fuel line; fill tank with clean, fresh

 

 

 

 

gasoline

 

3.

Vent in gas cap plugged.

3.

Clear vent.

 

4.

Water or dirt in fuel system.

4.

Drain fuel tank. Refill with fresh fuel.

 

5.

Dirty air filter.

5.

Clean or replace air filter.

 

6.

Carburetor out of adjustment.

6.

See qualified service center.

Engine overheats

1.

Engine oil level low.

1.

Fill crankcase with proper oil.

 

2.

Dirty air filter.

2.

Clean or replace air filter.

 

3.

Carburetor not adjusted properly.

3.

See qualified service center.

Occasional skip (hesitates)

1.

Spark plug gap too close.

1.

Adjust gap to .025”.

at high speed

 

 

 

 

Idles poorly

1.

Spark plug fouled, faulty or gap too

1.

Reset gap to .025” or replace spark

 

 

wide.

 

plug.

 

2.

Carburetor improperly adjusted.

2.

See qualified service center.

 

3.

Dirty air filter.

3.

Clean or replace air filter.

NOTE: For repairs beyond the minor adjustments listed above, contact your nearest Sears service center or other qualified service center or call 1-800-4-MY-HOME®.

13

Page 13
Image 13
Craftsman 316.2927 manual Troubleshooting, Problem, Cause, Remedy