CALIFORNIA PROPOSITION 65 WARNING

THE ENGINE EXHAUST FROM THIS PRODUCT CONTAINS

CHEMICALS KNOWN TO THE STATE OF CALiFORNiA TO

CAUSE CANCER, BIRTH DEFECTS OR OTHER

 

 

REPRODUCTIVE HARM.

 

TABLE OF CONTENTS

 

Rules for Safe Operation

2

Warranty

Information

4

Assembly

Instructions

5

Know Your

Unit

.................................

5

Oil and Fuel

Information

6

Starting/Stopping

Instructions

7

Operating

Instructions

8

Maintenance

and

Repair Instructions

10

Cleaning

and Storage

13

Troubleshooting

Chart

14

Specifications

14

Parts List

....................................

 

E17

Service Numbers

........................

Backcover

SPARK ARRESTOR NOTE

NOTE: For users on U.S. Forest Land and in the states of California, Maine, Oregon and Washington. All U.S. Forest Land and the state of California (Public Resources Codes 4442 and 4443), Oregon and Washington require, by law that certain internal combustion engines operated on forest brush and/or grass-covered areas be equipped with a spark arrestor, maintained in effective working order, or the engine be constructed, equipped and maintained for the prevention of fire. Check with your state or local authorities for regulations pertaining to these requirements. Failure to follow these requirements could subject you to liability or a fine. This unit is factory equipped with a spark arrestor. If it requires replacement, ask a Sears or other qualified service dealer to install the Accessory Part #753-05297 Spark Arrestor Kit.

WARNING: When using the unit, you must follow the safety rules. Please read these instructions before operating the unit in order to ensure the safety of the operator and any bystanders. Please keep these instructions for later use.

All information, illustrations, and specifications in this manual are based on the latest product information available at the

time of printing. We reserve the right to make changes at any time without notice.

,, iMPORTANT SAFETY INSTRUCTIONS ,,

READ ALL INSTRUCTIONS BEFORE OPERATING

=Read the instructions carefully. Be familiar with the controls and proper use of the unit.

Do not operate this unit when tired, ill, or under the influence of alcohol, drugs, or medication.

Children and teens under the age of 15 must not use the unit, except for teens guided by an adult.

All guards and safety attachments must be installed properly before operating the unit.

Inspect the unit before use. Replace damaged parts. Check for fuel leaks. Make sure all fasteners are in place and secure. Replace parts that are cracked, chipped, or damaged in any way. Do not operate the unit with loose or damaged parts.

Use only Hassle Free IIITM XRTA QUIETSpiral Line. Never use metal-reinforced line, wire or rope. These can break off and become dangerous projectiles.

Be aware of risk of injury to the head, hands and feet. Clear the area to be cut before each use. Remove rocks, broken glass, nails, wire, string and other objects which may be thrown or become entangled in the cutting attachment. Clear the area of children, bystanders and pets; keep them outside a 50-foot (15 m) radius, at a minimum. Even then, they are still at risk from thrown objects. Encourage bystanders to wear eye protection. If you are approached, stop the unit immediately.

Squeeze the throttle control and check that it returns automatically to the idle position. Make all adjustments or repairs before using unit.

FUEL SAFETY WARNINGS FOR GAS UNITS

vapors can explode if ignited. Take the following

I_ARNING: Gasoline is highly flammable, and its precautions:

Store fuel only in containers specifically designed and approved for the storage of such materials.

Avoid creating a source of ignition for spilled fuel. Do not start the engine until fuel vapors dissipate.

Always stop the engine and allow it to cool before filling the fuel tank. Never remove the fuel tank cap or add fuel when the engine is hot. Never operate the unit without the fuel cap securely in place. Loosen the fuel tank cap slowly to relieve any pressure in the tank.

Add fuel in a clean, well-ventilated outdoor area where there are no sparks or flames. Remove the fuel cap slowly, and only after the engine stops. Do not smoke while fueling. Wipe up any spilled fuel from the unit immediately.

Move the unit at least 30 feet (9.1 m) from the fueling source and site before starting the engine. Do not smoke. Keep sparks and open flames away from the area while adding fuel or operating the unit.

WHILE OPERATING

Never start or run the unit inside a closed room or building.

Breathing exhaust fumes can be fatal. Operate this unit only in a well-ventilated outdoor area.

Wear safety glasses or goggles that meet ANSI Z87.1 standards and are marked as such. Wear ear/hearing protection when operating this unit. Wear a face or dust mask if the operation is dusty.

Wear heavy long pants, boots, gloves and a long sleeve shirt. Do not wear loose clothing, jewelry, short pants, sandals or go barefoot. Secure hair above shoulder level.

The cutting attachment shield must always be in place while operating the unit as a trimmer. Do not operate unit without both trimming lines extended, and the proper line installed. Do not extend the trimming line beyond the length of the shield.

This unit has a clutch. The cutting attachment remains stationary when the engine is idling. If it does not, take the unit to a Sears or other qualified service dealer for an adjustment.

Adjust the D-handle to your size in order to provide the best grip.

Be sure the cutting attachment is not in contact with anything before starting the unit.

Page 2
Image 2
Craftsman 316.79194 manual California Proposition 65 Warning, Table of Contents, Spark Arrestor Note, While Operating

316.79194 specifications

The Craftsman 316.79194 is a versatile and reliable power tool designed for both professionals and DIY enthusiasts. This highly popular product boasts a range of features that enhance its performance and efficiency, making it a staple in many toolboxes.

One of the standout features of the Craftsman 316.79194 is its powerful motor. With a robust wattage, this tool is capable of delivering high torque, ensuring it can tackle a variety of tasks, from light household projects to more demanding jobs. The motor's design also incorporates advanced cooling technology, which helps prevent overheating during prolonged use, thereby extending the lifespan of the tool.

Another key characteristic of the Craftsman 316.79194 is its ergonomic design. The handle is crafted with comfort in mind, featuring a soft-grip surface that minimizes vibration and reduces user fatigue during longer periods of operation. This thoughtful design enhances control, allowing users to maneuver the tool with precision and ease.

In terms of versatility, the Craftsman 316.79194 is equipped with multiple speed settings that cater to different applications. Users can easily switch between various speeds to suit the project at hand, making it equally effective for tasks such as drilling, sanding, and cutting. This adaptability means it can be used in a wide range of materials, from wood to metal, enhancing its utility for various trades and crafts.

Safety is another priority with the Craftsman 316.79194. It comes with integrated safety features such as an automatic shut-off mechanism that activates when the tool overheats or becomes overloaded. This ensures a safer working environment and protects both the user and the tool from potential damage.

The Craftsman 316.79194 also benefits from a durable construction, designed to withstand the rigors of frequent use. The materials used are not only sturdy but also resistant to impacts and wear, ensuring that the tool maintains its performance over time.

In conclusion, the Craftsman 316.79194 is a robust power tool that combines strong performance with innovative features. Its powerful motor, ergonomic design, versatile speed settings, and safety mechanisms make it an essential tool for anyone serious about their projects. Whether tackling home improvements or professional tasks, the Craftsman 316.79194 stands out as a reliable and efficient choice.