Craftsman 316.79194 manual Maintaintheproperoillevelinthecrankcaseitis, Fuel Type

WARNING:OVERFILLINGOILCRANKCASEMAY

CAUSESERIOUSPERSONALINJURYCheckand.

maintaintheproperoillevelinthecrankcase;itis

importantandcannotbeoveremphasizedCheck.

theoilbeforeeachuseandchangeitasneeded.

See Changing the Oil.

RECOMMENDED OiL TYPE

Using the proper type and weight of oil in the crankcase is extremely important. Check the oil before each use and change the oil regularly. Failure to use the correct oil, or using dirty oil, can cause premature engine wear and failure.

Use a high-quality SAE 30 weight oil of API (American Petroleum Institute) service class SF, SG, SH.

ADDING OiL TO CRANKCASE: INITIAL USE

NOTE: This unit is shipped without oil. In order to avoid damage to the unit, put oil in the crankcase before you attempt to start the unit.

Your unit is supplied with one 3.04								_		_
fluid oz. (90 ml.) bottle of SAE 30
SF, SG, SH oil (Fig. 3).
NOTE: Save the empty oil bottle.
	,tcanbeusedtomeasureF.noe,
	the correct			amount	during		-_pout
	future		oil changes.		See
	Changing			the Oil.				Fig.	3
1. Unscrew the top of the
bottle		of oil and remove			the	Oil	Fill	(__
paper		seal covering the				Plug ----_._ __
opening.			Replace the top.
Next,		cut	the tip off the			O-Ring		___
funnel spout (Fig. 3).
2. Tip	unit so that			the back of		Oil Fill		\_, V		_,
the	engine is facing up				in a	Hole		\	\	'_
vertical position.								Fig. 4
the	crankcase			(Fig. 4).		_._

4.Pour the entire bottle of oil into the oil fill hole (Fig. 5).

NOTE: Never add oil to the fuel _.

3.	or fuel tank.	_	_	_°_
	Remove the oil fill plug from _4
5.	Wipe up any oil that may
	have spilled and reinstall the
	oil fill plug.

Check oil before	each use and	Fig.'5
change as needed. Refer to
Checking the Oil Level.
RECOMMENDED	FUEL TYPE

Old fuel is the primary reason for improper unit performance. Be sure to use fresh, clean, unleaded gasoline.

NOTE: This is a four cycle engine. In order to avoid damage to the unit, do not mix oil with gasoline.

Definition of Blended Fuels

Today's fuels are often a blend of gasoline and oxygenates

such as ethanol, methanol or MTBE (ether). Alcohol-blended fuel absorbs water. As little as 1% water in the fuel can form

acids when stored. Use fresh fuel (less than 60 days old), when using alcohol-blended fuel.

Using Blended Fuels

If you choose to use a blended fuel, or its use is unavoidable, follow recommended precautions:

•Always use fresh unleaded gasoline

•Use a gas stabilizer fuel additive

•Drain tank and run the engine dry before storing unit

Using Fuel Additives

The use of a gas stabilizer will inhibit corrosion and minimize the formation of gum deposits. Using a fuel additive can keep fuel from forming harmful deposits in the carburetor for up to six (6) months. Add 0.8 oz. (23 ml.) of fuel additive per gallon of fuel according to the instructions on the container. NEVER add fuel additives directly to the unit's gas tank.

							I
	outdoor	area. Wipe up any spilled			fuel immediately.		I
[_	Avoid creating a source			of ignition	for spilt fuel. Do		I
	WARNING:		Add fuel in a clean, well			ventilated
	not start	the	eng ne unt	fue vapors		d ss pate.	j

WARNING: Gasoline is extremely flammable. Ignited vapors may explode. Always stop the engine and allow it to cool before filling the fuel tank. Do not smoke while filling the tank. Keep sparks and open flames at a distance from the area.

FUELING THE UNiT

!_	injury from fuel spray.		Never	operate the unit	1
	WARNING:	Remove	fuel cap slowly to avoid
	without the	fuel cap securely		in place.	!

1.Remove the fuel cap (Fig. 6).

Fig. 6

2.Place the gas container's spout into the fill hole on the fuel tank (Fig. 5) and fill the tank.

NOTE: Do not overfill the tank.

3.Wipe up any gasoline that may have spilled.

4.Reinstall the fuel cap.

5.Move the unit at least 30 ft. (9.1 m) from the fueling source and site before starting the engine.

NOTE: Dispose of the old gasoline in accordance to Federal, State and Local regulations.