Craftsman 316.79194 manual Muffler SparkPlug OilFillPlug, Instalmng and Adjusting the D=HANDLE

Muffler SparkPlug

OilFillPlug

INSTALMNG AND ADJUSTING THE D=HANDLE

To Install

1.Place the D-handle down on to the shaft housing and the bottom clamp so that the handle slants toward the shaft grip (Fig. 1). Place handle and clamp a minimum of 6 inches from the end of the shaft grip.

Shaft Grip	Fuel
	Cap	Cold
Control		Starting
	Starter	Lever
D-Handle
	Rope
	Grip
Twist & Edge
and Craftsman	Throttle
ConvertibleTM
Coupler	Controm
Shaft	Air Filter	Primer
		Bulb
Housing	Cover
	Line
	Cutting
	Blade

. AttacC , Sh,e,d

HassieFree TM

On/Off Stop Control (4) Screws

Shaft !

Housing

Shaft Grip

Minimum 6 (15.24 crn)

Bottom Clamp

Fig. f

2.Start screws with a large Flat- head or T-25 Torx screwdriver. Do not tighten until the handle is adjusted.

To Adjust

3.While holding the unit in the operating position (Fig. 2), postion the D-handle to the location that provides you the best grip.

4.Tighten the clamp screws evenly, until the D-handle is secure.

iNSTALL LiNE TRIMMER

ATTACHMENT
NOTE: To make installation easier,
place the unit on the ground
or on a workbench.	Fig. 2

1.Turn knob counterclockwise to loosen coupler (Fig. 15, p. 9).

2.While firmly holding attachment, push it straight into the coupler until the release button snaps into the primary hole (Fig. 16, p. 9).

NOTE: Aligning the release button with the guide recess (Fig. 16, p. 9) will help installation.

3.Turn the knob clockwise to tighten.

LiNE TRIMMER APPMCATIONS

Cutting grass and light weeds; edging; and decorative trimming around trees, fences, etc.