attachment,readandunderstandthemanualthat
camewiththeattachmentFollowallsafety.
[_1 WARNING:Beforeyoubeginusinganyinformationcontainedwithin.
damagetotheunit,shuttheunitoffbefore
!_l
USING THE CRAFTSMAN CONVERTIBLE TM FEATURE
You can convert this unit to edge | g0 ° Edging | Hole |
grass. | (Trimmer | Onh |
1.Make sure the unit is turned completely off.
2.Turn the knob counterclockwise to loosen coupler (Fig. 15).
3.Push in the release button (Fig. 16) and twist the shaft 90 ° until
the release button snaps into the Knob 90 ° hole (Fig. 15).
4.Turn the knob clockwise to lock
the coupler (Fig. 17). |
| Fig. 15 |
Craftsman Convertible | TM |
|
Coupler | Primary Hole | Release Button |
Guide Recess
Fig. 16
Upl
Boom
Attachment
CRAFTSMAN CONVERTIBLE TM FEATURE
CAUTION: These
The coupler allows you to convert this unit for use with the following
• Cultivator
Blade Edger
Blower
Brush Cutter
Pruner
To Install Attachments
CAUTION: Before operating this unit, be sure ] that the release button is fully snapped into the I primary hole (Fig. 16), and that the knob (Fig. 17) is securely tightened.
NOTE: To make installation easier, place the unit on the ground or on a workbench.
1.Make sure the unit is turned completely off.
2.Turn the knob counterclockwise to loosen the coupler (Fig. 15).
3.While firmly holding the attachment, push it straight into the coupler until the release button (Fig. 16) snaps into the primary hole (Fig. 16). The primary hole is on the opposite side of the coupler from the knob (Fig. 16). Align the release button with the Guide Recess (Fig. 16) to help installation.
4.Turn the knob clockwise to tighten.
To Remove Attachments
1.Make sure the unit is turned completely off.
2.Turn the knob counterclockwise to loosen the coupler.
3.Press and hold the release button (Fig. 16).
4.While firmly holding the upper shaft boom (Fig. 17), pull the attachment out of the coupler.
Knob
Fig. t7