![](/images/new-backgrounds/1259488/25948819x1.webp)
TIGHTENING | SCREWS | AND | Fig. 9 | \ |
NUTS (Fig. | 9) |
| ||
|
|
1.Install the correct bit.
2.Apply just enough pressure to keep the bit engaged on the screw or nut.
3.Position the
4.Apply minimal pressure to the trigger switch initially. Increase the speed only when full control can be maintained.
_i WARNING: Do not
LOOSENING | SCREWS AND | NUTS (Fig. 10) | |
1. Install the | correct bit. | [ | Fig. 10 |
|
| / |
|
2.Apply just enough pressure to keep the bit engaged on the screw or nut.
3.Position the
right of the tool for forward rotation.
4.Apply minimal pressure to the trigger switch initially. Increase the speed only when full control can be maintained.
I_ f-'lI11i 11I-'I1[*']=1
A
All WARNING: To avoid serious personal injury, always remove the battery pack from the tool when cleaning or performing any maintenance.
WARNING: When servicing, use only identical Craftsman replacement parts. Use of any other parts may create a hazard or cause product damage.
&
_. WARNING: It is not recommended to use compressed dry air as a cleaning method for the
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from various types of commercial solvents and may be damaged by their use. Use clean cloths to remove dirt, dust, oil, grease, etc.
_, WARNING: Do not at any time let brake fluids, gasoline, petroleum- based products, penetrating oils, etc. to come in contact with plastic parts. Chemicals can damage, weaken or destroy plastic which may result in serious personal injury.
WARNING: When servicing, use only identical Craftsman replacement parts. Use of any other parts may create a hazard or cause product damage. To ensure safety and reliability, all repairs should be performed by a qualified service technician at a Sears Service Center.
17562 ManuaLRevised_$0 | 0607 | Page 18 | 17562 ManuaLRevised_10 | 0607 | Page 19 |