STEP 17: iNSTALL HOSE CLiP AND SPACER
(SEE FIGURE 16)
Secure the dump cable to the back of the bucket using a hose clip (QQ), a #10 x 5/8"
(L) and a
/
a..
| '_...., #10 x | 5/8" |
HOSE | TRUSS |
|
CLiP (QQ) | HEAD | BOLT (L) |
FIGURE 16
INSTALL FRONT SCOOP ON TRACTOR
STEP 18: iDENTiFY YOUR TRACTOR TYPE (SEE FIGURE 17)
Look underneath the front axle of your tractor. If there is a single mower deck suspension bracket located under the middle of the front axle, continue on to step 19. If your tractor does not have a mower deck suspension bracket underneath the middle of the front axle, skip to step 21 on page 13 or step 23 on page 14 for tractors with dual suspension brackets.
LAWN TRACTORS AND GARDEN TRACTORS
WiTH SINGLE SUSPENSION BRACKETS
STEP 19: iNSTALL SiDE PLATES
(SEE FIGURE 18)
Remove any bolts present in the mounting holes on the left side of the tractor frame. Do not remove bolts
from right side of frame until left side plate has been installed.
Install the left (long) side plate on the tractor frame using three 3/8" x 1" carriage bolts (J), three 3/8" nylock nuts (R), one 5/16" x 1" carriage bolt (K), one 5/16" nylock nut (S) and three large 1/2" washers (11)if needed (see note). Do not tighten yet. Repeat for the right side plate.
NOTE: If an engine mounting plate is present (shown with dotted lines) that prevents the side plate from resting flat against the tractor frame, place 1/2" washers (ll) on the front two 3/8" bolts and on the rear 5/16" bolt to serve as shims between the side plate and the frame.
(3) 3/8" x 1" | 5/16" × 1" |
CARRmAGE BOLTS (J) | CARRIAGE BOLT (K) |
ENGmNE |
|
MOUNTmNG | |
PLATE | 5/16" |
| NYLOCK |
| NUT (S) |
(SEE NOTE)
LEFT | (LONG) | (3) 3/8" NYLOCK |
SiDE | PLATE | NUTS(R) |
FIGURE 18
MOWER DECK
SUSPENSION
BRACKET
FIGURE 17
12