Craftsman 486.248473 manual INSTALL LiFT Handle Tube see Figure, INSTALL LiFT Cable

STEP 10: iNSTALL TiLT STOP BRACKETS

(SEE FIGURE 9)

Install a tilt stop bracket (PP) to each side of the bucket using a 3/8" x 1" carriage bolt (J), 3/8" washer

(EE)and 3/8" nylock nut (R). Do riot tighter= the nuts until step 27.

TILT STOP

BRACKET (PP)

STEP 12: iNSTALL LiFT HANDLE TUBE EXTENSION

(SEE FIGURE 11)

Install the lift handle tube extension on the lift handle tube using a 1/4" x 1-3/4" hex bolt (H) and 1/4" nylock nut (T).

LIFT HANDLE	1/4" x 1-3/4"
TUBE EXTENSION	HEX BOLT (H)	LIFT HANDLE
	_,	TUBE

318" NYLOCK
NUT (B)	3/8" x 1" J_
318"WASHER (EE)	CARRIAGE BOLT (J)
FIGURE 9

STEP 11: iNSTALL LiFT HANDLE TUBE (SEE FIGURE 10)

Install the lift handle tube into the index bracket using two 5/16" x 1-3/4" hex bolts (G) and 5/16" nylock nuts

(S).

	LIFT HANDLE
	TUBE
5/16" NYLOCK	5/16" × 1-3/4"
NUTS (S) _\k	HEX BOLT (G)
/	INDEX

1/4" NYLOCK NUT (T)

FIGURE 11

STEP 13: iNSTALL LiFT CABLE

(SEE FIGURE 12)

Connect the hooked end of the lift cable into the index rod, and install the threaded cable adjuster into the

notch in the top of the index bracket, placing a nut on each side of the notch.

Adjust the cable adjustment nuts so that when the lift trigger is squeezed, the bottom of the index rod raises enough to release from the latched position. The index rod should also lower far enough to lock in the latched position when the trigger is released.

Attach the lift cable to the lift handle using three cable ties (OO).

LIFT TRIGGER

LIFT CABLE

CABLE

N UTS

FIGURE 10

INDEX ROD

FIGURE 12

10