Klark Teknik DN9344E, DN9340E Safety Warning, Installation Considerations, After Unpacking

ATTENTION!

Please ensure that you read and follow the

IMPORTANT SAFETY INSTRUCTIONS at the front of this manual and the SAFETY WARNINGS and INSTALLATION CONSIDERATIONS given below.

Safety Warning

To prevent shock or fire hazard, do not expose the unit to rain or moisture. To avoid electrical shock do not remove covers. Refer servicing to qualified personnel only.

This unit is fitted with a standard fused IEC mains power socket. The unit contains a switch mode power supply that automatically adjusts itself to 50/60Hz mains supplies in the 100V to 240V (±10%) AC range. This information is printed on the rear of the unit, adjacent to the mains inlet socket.

Before connecting this unit to the mains supply, ensure that the fuse fitted is the correct type and rating as indicated on the rear panel.

For safety reasons the mains earth lead should never be disconnected. In the event of ground loop problems, disconnect the signal screen at one end of the connecting cables – note that this can only be done when the unit is used within a balanced system.

	Installation Considerations
Location:	Do not install this unit in a location subjected to excessive heat, dust or
	mechanical vibration. Allow for adequate ventilation around the unit, making sure
	the unit’s fans and vents are not obstructed. To prevent excessive heating of the
	unit, avoid mounting the unit directly above power amplifiers or other devices
	that radiate significant amounts of heat. Where necessary, use fan cooled racks.
Cables:	To ensure correct and reliable performance, this product should only be used with
	high quality, screened twisted pair audio cables, terminated with metal-bodied
	3-pin XLR connectors (Pin 2 Hot).
Electric Fields:	Should this product be used in an electromagnetic field that is amplitude
	modulated by an audio frequency signal (20Hz to 20kHz), the signal to noise ratio
	may be degraded. Degradation of up to 60dB at a frequency corresponding to the
	modulation signal may be experienced under extreme conditions (3V/m, 90%
	modulation).

After Unpacking

Please retain the original packing for use should you need to transport or ship this unit.

Please inspect the unit carefully for any signs of damage that may have occurred in transit and notify the courier immediately if you feel that any damage has occurred.

1