Klark Teknik DN9344E specifications Operation DN9340E, 6.5.3Touchstrip operation with Filters

Operation: DN9340E

Filter settings page

•Filter type - available types are Notch, Low Pass (normal and peaking), High Pass (normal and peaking), Hi Shelf and Lo shelf.

•Graph display - three modes are available, to ensure that clear information is available for any application. “Curve” mode shows the overall response of the whole filter module. “Active” mode shows just the response of the single filter currently being selected for adjustment. “Individual” mode shows all the filters, but as individual curves rather than as a single composite response.

Filter remove page

This page allows the currently selected filter to be deleted entirely (as opposed to bypassed - see IN/OUT below). The centre encoder is turned clockwise to remove the filter, and then the right encoder is also turned clockwise to confirm.

Turn the left encoder to select the type of filter required. The available options are Notch, Low-pass (normal and peaking), High-pass (normal and peaking), Hi shelf and Lo shelf. Turn the right encoder to confirm the selection and create the filter. There are four filters available to each channel, each of which can be used across the whole frequency range from 20Hz to 20kHz.

6.5.3Touchstrip operation with Filters

On the Filters page, the touchstrip can be used to select the currently active filter. If you are not currently using the Freq/Level menu, the unit automatically switches to it when you press the touchstrip. Press either the upper or lower part of the strip below the centre frequency of the required filter. The centre frequency will highlight to indicate the selection. Once selected, the frequency of the filter can be dragged up and down the display by pressing the strip and sliding the point of contact to left and right. There is no difference between the upper and lower strips when in Filter mode.

23