iNSTRUCTiONS FOR ALL TRACTORS
STEP 24: MOUNT SCOOPTOTRACTOR (SEE FIGURE 23)
Align the scoop with the side plates on the front of the tractor. Lift the rear of the scoop and slide the notches in the scoop frame onto the bolts or pins in the tractor side plates. Stand on the left side of the tractor and push down on the scoop dump handle until the holes in the scoop frame and the holes in the side plates are aligned. Install the attachment rod through the holes from the left side and secure it with a long hairpin cotter (X).
DUMP HANDLE
LONG
HAIRPIN
COTTER (X)
/
BO_ OR PiN
• _ATTACHMENT
ROD
SCOOP _%
ASSEMBLY
FIGURE 23
STEP 25: ADJUSTTILT BRACKET AND PIN STOP BRACKET
(SEE FIGURE 24)
Lower the scoop assembly onto a smooth level surface. For normal use, let the bottom of the bucket rest flat on
the ground. For more aggressive scraping action, place 1/4" shims under the rear of the bucket at each end.
If they are tightened, slightly loosen the two smaller bolts in the tilt bracket. If they are tightened, slightly loosen the four bolts in the pin stop bracket.
Swing the tilt bracket forward and position the pin stop bracket so the end of the dump control pin inserts into the hole in the tilt bracket.
Adjust the pin stop bracket so that it is square with the bucket leaving a small gap between the pin stop bracket and the tilt bracket. The taper on the end of the pin should now extend all the way through the tilt bracket. TIGHTEN the bolts and nuts in the pin stop bracket
TIGHTEN the two bolts and nuts in the tilt bracket.
SMALLER BOLTS
TILT BRACKET /
PIN STOP BRACKET
FIGURE 24
15
