dental starting when making
_ ARNING: To prevent acci- any adjustments or repairs,
always disconnect the spark plug wire and place it where it cannot make contact with the spark plug,
HOW TO ADJUST
THE AUGER DRIVE CABLE
The auger drive cable was adjusted at the factory. If the auger will not engage or disengage correctly. Adjust the auger drive cable as follows:
1.Loosen the nut that holds the cable tension spring (See Figure 14).
2.Slide the cable tension spring to- ward the rear of the unit until all cable slack is removed.
NOTE: The auger drive cable is properly adjusted when the free cable slack is removed and there is no tension on the idler arm,
3.Tighten the nut that holds the cable tension spring.
If belt stretch has occured, move the
end the auger drive cable to the out- side hole as follows:
1.Loosen the nut that holds the cable tension spring (See Figure 14).
2, Move the cable tension spring to- ward the front of the unit to achieve
maximum cable slack,
3, Remove the upper end of the auger drive cable from the auger drive lever.
4, Install the auger drive cable in the
hole shown in Figure 15.
5.Slide the cable tension spring to- ward the rear of the unit until all
cable slack is removed.
NOTE: The auger drive cable is
properly adjusted when the free cable slack is removed and there is
no tension on the idler arm.
6.Tightenthe nut that holdsthe cable tension spring.
Figure 14
Auger
DriveLever
Handle
Figure 15
18 |
