
HOW TO REMOVE
THE AUGER DRIVE BELT
The auger drive belt is made of special construction and must be replaced with
an original equipment belt available from the nearest Sears Store.
If the auger drive belt is damaged, the snowthrower will not discharge snow and will not move forward. Replace the damaged belt as follows:
1.Disconnect the spark plug wire. 2, Remove the belt cover. See "How
To Remove The Belt Cover".
3. Note the path of the auger drive |
belt. For assistance, a diagram de- |
cal is provided. |
4. Remove the belt guide screw and |
the belt guide See Figure 18). To |
remove the belt guide, rotate the |
belt guide down. |
5. Remove the idler screw and idler |
pulley from the idler arm (See |
Figure 19). |
6. Remove the auger drive belt from |
the engine pulley and pull through |
side of motor box (See Figure 20). |
7. To remove the auger drive belt |
from the impeller pulley, move the |
idler arm to the engaged position. |
This will provide clearance between |
the impeller pulley and the brake |
arm to remove the auger drive belt |
(See Figure 21). |
Idler
Figure 19
8. | To install a new auger drive belt, re* |
| verse the above steps. |
9. | Check the adjustment of the auger |
| drive cable. See "How To Adjust |
| The Auger Drive Cable". |
Auger Drive Belt
Impeller
Pulley
ure 20
Belt | Brake | Arm | |
Guide | |||
earance | Figure 21 | ||
Screw | |||
_i!i!i!!_ii!ii_i | .=18 |
| |
20 |
| ||
|