Specialized CR2302 manual Lost when changing batteries or computers Clock, Second Wheel Mode

lost when changing batteries or computers.

Clock

The SpeedZone Comp has two clocks, one digital and one analog. The digital clock is accessed by pressing the "MODE" button for three seconds. There is an option of either 12 hour or 24 hour clock settings and is shown on the lower line of the screen. The analog clock is always displayed in the upper right side of the screen. The minute hand of the analog clock has twelve segments and can only display time in five-minute increments. The hand will not jump to the next segment until the digital clock reaches whole five-minute intervals.

Second Wheel Mode

For riders who own more than one bicycle or who frequently change tires, the SpeedZone Comp is capable of storing two tire sizes. You can change between the two sized by pressing both the "MODE" and "FUNCTION" buttons simultaneously for three sec- onds. The second wheel mode indica- tor will change from 1 to 2. Mileage recorded will be cumulative between the two sizes. (An additional handle- bar mount is available from your Specialized dealer)

Triple Display LCD

The display screen on your SpeedZone Comp can provide three pieces of information simultaneously: Current Speed (always displayed on the top

line of the screen), Current Time (on analog clock), and your choice of one of the following: Average Speed, Maximum Speed, Current Time (digital clock), Trip Distance, Interval Timer or Odometer.

INSTALLING THE BATTERY Should you need to replace the bat- tery, push the computer backward to remove it from the handlebar mount. Before removing the battery make a note of your odometer reading and wheel circumference settings so that you can re-enter them when you restart the computer. Turn the computer over so the display is facing down- ward. Use a coin to unthread the bat- tery cap from the computer. Install the battery (model CR2302) with the posi- tive pole (+) facing upward. Carefully

FIGURE 15: BATTERY INSTALLATION

thread the battery cap back onto the case with a coin. (See Figure 15)

If the LCD display is blank or shows incomplete digits, turn the computer over and press the "AC" button on the bottom of the case with the tip of a pen or a paper clip. This will clear all the data and re-start the computer. Reinstall the computer by pushing it forward into the mount until it snaps into place.

16

17