Craftsman 580.32561 TfyouhaveanyprobbmswiththeassemMyofyour, Nstall Wheel Kit, Carten Centents

YourCraftsmangeneratorrequiressomeassemblyandis readyforuseonlyafterit hasbeenproperlyservbedwiththe recommendedoilandfuel.

tfyouhaveanyprobbmswiththeassemMyofyour

generator,please call the generater heb]ine at 1-80e-222-3136.

Unpacking the Generater

1.Set the carton on a rigid fiat surface.

2.Removeeverything from carton except generator.

3.Opencarton completely by cutting each corner from top to bottom.

4.Leavegenerator on carton to install wheel kit.

Carten Centents

Check alI contents against those listed below: o Main unit

oEngineoii

oOperator'smanuai Wheel kit

o Adapter cord set

If any parts are missing or damaged,call the generator helpline at 1=800=222=3136.

nstall Wheel Kit

NOTE:Wheel kit is not intended for over-the-road use. DO NOTtow this unit with a motorized vehicte.

You wiii needthe following tools to install these components:

o 13ram wrench

o Socket wrench with a 13ram socket o Pliers

o Safety gtasses

Install the Wheel }(it as Folbws:

1.Tip generator so that engine end is up.

2.Slide axle (A) through both mounting brackets.

3.Placea wheel (B) on each side as shown.

4.Macea washer (C) on axie and then place an e-ring (g) in axle groove.

5.InstalI e-ring with pliers, squeezingfrom top of e-ring to bottom of axle.

CAUTION

E-rings can cause eye injury.

E-rings can spring back and become airborne when installing or removing.

•Alwaysweareyeprotectionwheninstalling/removing-rings

6.Repeatsteps 4 and 5 to secure second wheei.

7.Tip generator so that engine side is down.

8.Line up holes in support leg (E) with holes in generator frame.

9.Attach support ieg using two short capscrews (MS x

16 ram) (F) and two iocking hex nuts (G). Tighten with a 13 mm socket and wrench.

10.Returngenerator to normat operating position (resting on wheels and support leg).